Sharp UX-S10 - Manual (Page 31)

Setup for SMS Test Messaging
29
2. SMS
T
e
x
t
Mes
s
ages
Entering your SMS center number
The number for the ANNY WAY center has been pre-stored. If you are going to
use the ANNY WAY center, you do not need to perform the following
procedure.
If you wish to initiate DT service, press in Step 4 below and enter the
number “8888” in Step 5. When finished, select “2nd” carrier as explained on
the following page, and then send an SMS message that simply says
“ANMELD” as explained on page 31.
Caution: Do not change the preset number for the ANNY WAY center.
2
1
Press and .
2
Press and .
3
Press .
4
Press to enter the number of the
2nd center.
5
Enter the number of the center (maximum of 32 digits).
•
To clear a mistake, press .
•
To enter a pause between any of the digits, press . The pause
appears as a hyphen.
6
Press .
7
Press to exit.
Note: If you wish to use the “2nd CENTER #”, be sure to select “2nd” in
the procedure on the following page.
SMS
2
FUNKTION
START/SPEICHER
STOP
Display:
SMS SETTING
SMS CENTER #
SELECT CARRIER
1=ANNYWAY, 2=2nd
2nd CENTER #
SMS RECEIVE