Manual registration gigaset s44, Charging batteries, Registering your phone charging batteries – Siemens GigasetS44 User Manual

Page 6: Registering your phone

Setting up the phone for use

Gigaset S44 / MEA engl / A31008-M1611-A611-1-7619 / start_guide_time.fm / 07.06.2005

Registering your phone

Before you can use your Gigaset S44 you

must register it to a base station. It can be

registered to a maximum of four base sta-

tions. The actual registration procedure

will depend on the type of base station.

Automatic registration Gigaset S44 to

Gigaset S440/S445

Important: The handset must not already

be registered to any base station.
The handset registers automatically to the

Gigaset S440/S445 base station.

Place the handset in the base station

with its display facing forward.

Registration takes about 1 minute. During

this process,

Regstr.Procedure

appears in

the display and the name of the base sta-

tion, e.g.

Base 1

, flashes. When the hand-

set has registered, its screen displays its

internal number, e.g.

INT 2

for internal

number 2. The handset will be assigned

the lowest unassigned number (1–6).

If all internal numbers 1-6 have been

assigned, number 6 is overwritten, if the

handset with the internal number 6 is in

idle status.

Manual registration Gigaset S44

If the handset does not activate automati-

cally when the batteries are fitted, you

have to charge the batteries first.
You must activate manual registration of

the handset at both the handset and the

base station.

After it has registered, the handset returns

to idle status. The internal number of the

handset appears in the display, e.g.

INT 1

Otherwise repeat the procedure.

1. On the handset

Handset

Register H/Set

Select base station, e.g.

Base 1

and press

§OK§

Enter the system PIN of the

base station (the default is

0000) and press

§OK§

. You will

see, e.g.

Base

2. On the base station

Start registration on the base station

within 60 seconds as described in the base

station's instructions.

Charging batteries

Plug the mains adapter of the charging

cradle into a mains power socket.

Place the handset in the cradle with its

display facing forward.

To charge the batteries, leave the handset

in the charging cradle. If the handset is

activated, the battery charging process is

indicated on the handset by the flashing

battery icon

e. During handset opera-

tion, the battery icon indicates the charge

status of the batteries (page 1).

First battery charge and discharge

The correct charge status can only be dis-

played when the batteries are first fully

charged and discharged.

To do this, leave the handset in the

charging cradle without interruption

for 10 hours. Your handset need not be

switched on to charge.

Once the batteries are fully charged,

remove the handset from the cradle

and do not put it back again until the

batteries are fully discharged.

Note:

– Automatic registration is only possible

while no-one is making calls using the base

station.

– Each key press cancels automatic registra-

tion.

– If automatic registration does not work,

you will have to register the handset manu-

ally.