Appendix, Care, Contact with liquid – Siemens GigasetS44 User Manual
Page 27: Care contact with liquid questions and answers, Questions and answers
26
Appendix
Gigaset S44 / MEA engl / A31008-M1611-A611-1-7619 / start_guide_time.fm / 07.06.2005
Appendix
Care
¤
Wipe the charging cradle and the hand-
set with a damp cloth (do not use sol-
vent) or an antistatic cloth.
Never use a dry cloth. This can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
1. Switch the handset off and remove
the batteries immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
4. Do not activate the handset again
until it is dry.
When it has fully dried out you will nor-
mally be able to use it again.
Questions and answers
If you have any queries about the use of
your handset, you can contact us at any
time at
The table below contains a list
of common problems and possible solu-
tions.
EATONI
predictive text
on
Alarm clock/appoint-
ment
off
Character set
standard
Function
Default
setting
Page
!
The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key
a
.
2. The batteries are flat.
¥
Charge or replace the batteries (page 4).
The handset does not respond to a key press.
The keypad lock is activated.
¥
Press and hold the hash key
#
"Base station x" flashes in the display.
1. The handset is outside the range of the base
station.
¥
Reduce the distance between handset/
base station.
2. The handset has been de-registered.
¥
Register the handset (page 5).
Base Search flashes in the display.
Handset is set for
Best Base
and no base station
is within range.
¥
Reduce the distance between handset/base
station.
Handset does not ring.
The ringtone is switched off.
¥
Activate the ringtone (page 21).
The other party cannot hear you.
You have pressed the
u
(INT) key. The hand-
set is "muted".
¥
Switch on the microphone again (page 11).
You hear an error tone when keying an input
(a descending sequence of tones).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the operating
instructions if necessary.