Smart Technologies Interactive Whiteboard SBFPD User Manual

Page 18

Installing the Interactive Whiteboard

99-00667-00 B0

7. Attach the second hanger bracket in the same way.

8. Place the mounting bracket over the flat-panel display with the left hanger bracket on your

right side. The left bracket goes on your right because you are looking at the back of the
flat-panel display. The hanger brackets should face towards the flat surface so that the
horizontal section of each bracket makes a U-shape, as shown in the figure below.

9. Using the supplied Installation Template as a guide, align the slotted holes in the mounting

bracket with the adapter plate bolt holes in the flat-panel display.

CAUTION

If the mounting bracket is mistakenly installed upside-down, the hanger
brackets won’t be able to support an overlay and the installation will be unsafe.

IMPORTANT

Obtain the best possible alignment before mounting either the flat-panel
display or the overlay. After you mount the overlay, you’ll be limited in how
much you can move the overlay relative to the flat-panel display. If the overlay
is aligned poorly, it obscures some of the flat-panel display’s screen.

CAUTION

Try not to position the mounting bracket over the flat-panel display’s cooling
vents. Blocking these vents could cause overheating and damage to the
flat-panel display.

Mounting Bracket

Center Section

Both hanger brackets

make a U-shape

Left hanger bracket

is on the right side

(when viewed

from the back)

Position Universal Bracket

between lines and

Note:

If your plasma panel has 8 mounting holes, 2 mounting

options may exist. Use the option which does not obscure
adjacent mounting holes.

Align the top of the universal bracket with line A.

Ensure the

bracket is centred left to right on the plasma panel.

Finish installing the PX350 as per your instruction manual.

Slide the universal bracket up the plasma panel, looking
through the slotted holes for the top mounting points on the
back of the plasma panel. Do not pass line B.

Align the top right corner of this template with the face down
plasma panel as shown below.

Do not pass this line

PX350 Installation Template

Installation Template