Sanyo SRT-4040DC - Manual (Page 19)

TAPE MANAGEMENT
Setting the Tape Management Function
1 Press the MENU button to display the MAIN MENU.
2 Press the l (or j ) button to select the “6.TAPE
MANAGEMENT” line, then press the ENTER button.
ø The (TAPE MANAGEMENT) menu appears.
*TAPE@MANAGEMENT@@@@N
*PROTECT@DAY@@@@@@@30
*REC@PASS@SET@@@@@@10
*[email protected]@@@@@OFF
*OVERRIDE@@@@@@@@@@@N
3 Press the ENTER button.
4 Press the l (or j ) button to select the desired
mode, then press the ENTER button.
N. . . . . . . The tape management function is not
active.
Y. . . . . . . The tape management function is
active.
When setting to “Y”, please continue with the
settings below.
5 Press the l (or j ) button until the “PROTECT DAY”
setting is highlighted, then press the ENTER button.
6 Press the l (or j ) button to select the desired
number of days to protect the tape, then press the
ENTER button.
OFF . . . . The tape is not protected
1-255 . . . Number of days to protect the tape
(prevent over-recording), from the date
of the last recording on the tape (or the
last expected recording date (calculated
using the tape length (T-120 or T-160)
and the recording speed)).
NOTE:
œ Since the last expected recording date is a
calculated date (using the tape length (T-120 or
T-160) and the recording speed), it may be
different from the actual last recording date, due
to other settings such as alarm recordings,
program timer recordings and holiday settings.
7 Press the l (or j ) button until the “REC. PASS
SET” setting is highlighted, then press the ENTER
button.
8 Press the l (or j ) button to select the desired
number of re-recording times, then press the ENTER
button.
OFF . . . . The number of re-recording times will
not be checked.
1-100 . . . Maximum number of re-recording
times. (Refer to “Concerning the
Number of Times Tapes can be
Rerecorded on” on page 21.)
NOTES:
œ Since data is read before it is recorded, the
number of times will be incremented even if the
recording is stopped before the end.
œ During autorepeat recording, the re-recording
times count will be updated every time the tape is
rewound to the beginning. Autorepeat recording
will proceed even if the count exceeds the “REC
PASS SET” setting.
9 Press the l (or j ) button until the “GROUP NO.
SET” setting is highlighted, then press the ENTER
button.
F Press the l (or j ) button to select the desired group
number, then press the ENTER button.
OFF . . . . The group number will not be checked.
1-15 . . . . Group number setting.
G Press the l (or j ) button until the “OVERRIDE”
setting is highlighted, then press the ENTER button.
H Press the l (or j ) button to select the desired
override mode, then press the ENTER button. (Refer
to “Tape Management Conflict Display” on the next
page.)
N. . . . . . . Only EJECT button operation is
accepted after a conflict has occurred.
Y . . . . . . . The next operation is accepted after a
conflict has occurred. This will override
setting.
I Press the MENU EXIT button.
NOTES:
œ
Once the tape management data is recorded on
tape, it cannot be changed.
œ The criteria (condition) for allowing recording will be
based on the data recorded on the tape and not the
settings in the (TAPE MANAGEMENT) menu.
NB4QR/NA (SRT-4040 GB) Tue. Sept., 10/2002
18
English