Sony PEG-T615C - Manual (Page 69)

69
CLIÉ Remote Commander
Chapter 5
Using the CLIÉ handheld as a remote
commander
You can operate a remote-controlled device on the device’s control
screen. For those operations you have assigned to the Jog Dial
™
navigator or to the application buttons, see page 67.
Notes
• Be sure to point the IR port of your CLIÉ handheld toward the
device that you wish to remote-control.
• The reach of the remote-control signal is approximately 5 meters, but
it may vary depending on the receiving device or on the
environment.
Remote-controlling a device
Operating a device from the control screen
1
On the Application Launcher screen, rotate the Jog Dial ™
navigator to select CLIÉ RMC and press the Jog Dial
navigator. Or, tap the CLIÉ RMC icon on the Application
Launcher screen.
CLIÉ Remote Commander application starts and control screen for
the last used device appears.
Note
If the setting for the last used device has been deleted, the Select Control
screen appears.
2
Perform either of the following to switch to the control
screen of the device you are about to remote-control.
• For devices assigned to a quick-start button:
Tap the quick-start button to which it is assigned.
• For devices unassigned to a quick-start button:
Tap Select, then tap to select the name of the remote
control setting from the list.
The control screen for the selected device appears.
3
Tap the onscreen buttons to remote-control the device.