Siemens optiPoint 400 User Manual
Page 78
Step by Step
Using Other Functions
78
Using System Functions from the Outside
(DISA: Direct Inward System Access)
If this function has been configured (contact your serv-
ice personnel), you can set up external outgoing calls
from outside the system, just like an internal user. You
can also activate and deactivate the following functions
in your system:
•
Reset services and functions,
code: #0
•
Call forwarding, code:
*
•
Lock and unlock all phones,
code:
*
66/#66
•
Save PIN,
code:
*
•
Send a message,
code:
*
68/#68
•
Leave an advisory message,
code:
*
69/#69
•
Group ringing, code:
*
81/#81
•
Group call, code:
*
85/#85
•
Suppress caller ID,
code:
*
86/#86
•
Waiting tone, code:
*
87/#87
•
Open door, code:
*
61
Æ Page 30
•
Door opener on/off, code:
*
89/#89
Æ Page 30
•
Control relay, code:
*
90/#90
•
Do not disturb, code:
*
97/#97
•
Ringer cutoff function, code:
*
•
Speed-dialing, code:
*
7
Æ Page 35
•
Associated service, code:
*
83
Precondition: You have a telephone that uses tone di-
aling (DTMF dialing) or you can switch your telephone
to tone dialing. The telephone is not connected to the
system.
o
Set up a call to the system. Enter the station number
(contact your service personnel).
o
Wait for a continuous tone (if necessary switch the tel-
ephone to tone dialing), then enter the internal number
that has been assigned to you and the associated PIN.
r
Enter the code (necessary only if programmed in the
system).