2-6. snmp – Sony SRX-T420 User Manual
Page 50
2-10
SRX-T420
Fig. 2-2-6
2-2-6. SNMP
SNMP (Simple Network Management Protocol) is set.
SNMP
sysName:
Type the character string of standard MIB sysName.
Contact:
Type the character string of standard MIB sysContact.
Location:
Type the character string of standard MIB sysDescr.
Send authentication trap: Place a check mark when accepting the sending of authentication trap.
Accept SNMP packets from any host:
Select this when accepting the access from any host.
Accept SNMP packets from these hosts: Select this when accepting the access only from the specifi ed
host.
(Address):
Type the IP address of the host that you accept the access.
[>>] button:
Add the typed IP address of the host to the list.
[<<] button:
Delete the typed IP address of the host from the list.
(Registration list):
Registration list of the IP address of the host that you accept the access.
Community:
Edit and select the community name.
. [Add] button:
Add the community name.
. [Edit] button:
Allow the selected community to enter the attribute edit mode.
. [Remove] button: Delete the selected community.
Community name:
When the [Edit] button is clicked, the community whose attribute is changed
appears and the following items are enabled.
Rights:
Select the access authority.
[Set|to|List] button:
Attribute change is applied.
[Cancel] button:
Attribute change is cancelled.
Trap Destinations:
Type the IP address of the host of the trap destination.
[>>] button:
Add the typed IP address of the host to the list.
[<<] button:
Delete the typed IP address of the host from the list.
(Registration list):
Registration list of the IP address of the host of the trap destination.