Sony SRX-T420 - Manual (Page 27)

1-21
SRX-T420
In case of LKRI-005
m
. For INPUT A slot, LKRI-005 is installed by default. However, LKRI-003 can be installed.
. When using a long cable, the image may not be displayed properly due to the signal attenuation.
. When the 10 bit single mode is selected, the DVI cable applicable to Dual-link is required.
1. Connect the commercially available DVI cable to the
terminal according to the input signal.
Input signal Used terminal
During normal operation
DVI1.0 compliant
Signal level: Full Range DVI-D terminal
10 bit signal of its own specifi cation
During input (10 bit twin mode)
Signal level: Full Range DVI-D terminal
and AUX terminal
10 bit signal of its own specifi cation
During input (10 bit single mode)
Signal level: Full Range DVI-D terminal
Used during signal input of DTV standard
DVI1.0 compliant
Signal level: Limited Range DVI-D terminal
10 bit signal of its own specifi cation
During input (10 bit twin mode)
Signal level: Limited Range DVI-D terminal
and AUX terminal
10 bit signal of its own specifi cation
During input (10 bit single mode)
Signal level: Limited Range DVI-D terminal
Pin location
DVI-D terminal, AUX terminal
Pin No. Signal name Pin No. Signal name
1 DATA2 _ 13 DATA3 +
2 DATA2 + 14 +5 V
3 GND 15 DDC_GND
4 DATA4 _ 16 HOTPLUG_DET
5 DATA4 + 17 DATA0 _
6 DDC_SCL 18 DATA0 +
7 DDC_SDA 19 GND
8 NC 20 DATA5 _
9 DATA1 _ 21 DATA5 +
10 DATA1 + 22 GND
11 GND 23 CLK +
12 DATA3 _ 24 CLK _
LKRI-005
To DVI-D terminal
To DVI output terminal
DVI-D cable
(optionally available)
To AUX terminal
Personal computer
Fig. 1-7j
17 18 19 20 21 22 23 24
9 10 11 12 13 14 15 16
1 2 3 4 5 6 7 8