beautypg.com

Troubleshooting (continued) – Sony KWP 65HD1 User Manual

Page 80

background image

76

Good picture, no sound

Press MUTING so that “MUTING” disappears
from the screen.
(see “MUTING” on pages 29, 37)

Check the MTS setting in the AUDIO menu.
(see “MTS” on page 49)

Make sure SPEAKER is set to ALL ON or L/R
OFF in the AUDIO menu. (see “SPEAKER” on
page 49)

Perform AUTO SET UP again using “Auto
Program” for digital channels, or using the
SET UP button for conventional TV channels
to return to the factory preset condition. (see
“To perform AUTO SET UP again” on page
26)

No picture on a digital channel

Switch to a different digital channel.

Cannot receive digital channels

Press DTV ANT on the remote control so
that the TV (FUNCTION) indicator lights up
in green momentarily.

Make sure that VHF/UHF antenna is
connected to both VHF/UHF IN and VHF/
UHF (DTV) IN on the projection TV.
You cannot receive digital channels unless
you connect an analog terrestrial antenna.
This is true even if you normally receive your
programming through cable or satellite.

Use “DTV Auto Add” in the Channel Setup
menu to add receivable DTV channels that
are not presently in DTV memory.

Make sure that the DTV I/O cable is
connected to both the lower and upper
panels at the rear of the projection TV.

Check your local listings to find out if you
can receive digital broadcasts in your area.

Unable to select a digital channel

Use “DTV Auto Add” in the “Channel Setup”
menu to add receivable DTV channels that
are not presently in DTV memory.

Cannot receive conventional TV channels

Press TV ANT on the remote control so that
the TV (FUNCTION) indicator lights up in
red momentarily.

Cannot receive upper channels (UHF) when
using an antenna

Make sure CABLE is OFF in the CHANNEL
SET UP menu. (see “CABLE” on page 54)

Use AUTO PROGRAM to add receivable
channels that are not presently in the TV’s
memory. (see “AUTO PROGRAM” on page
54)

No color

Adjust the COLOR in the VIDEO menu. (see
“COLOR” on page 47)

Black and white programs cannot be seen in
color.

Perform AUTO SET UP again using “Auto
Program” for digital channels, or using the
SET UP button for conventional TV channels
to return to the factory preset condition. (see
“To perform AUTO SET UP again” on page
26)

Only snow and noise appear on the screen

Check the CABLE setting in the CHANNEL
SET UP menu. (see “CABLE” on page 54)

Check the antenna/cable connections.

Make sure the channel is broadcasting
programs.

Press TV ANT to change the input mode.
(see “TV ANT” on page 36)

Dotted lines or stripes

Adjust the antenna.

Keep the projection TV away from noise
sources such as cars, neon signs or hair-
dryers.

Troubleshooting (continued)