Sony KWP 65HD1 - Manual (Page 78)

74
Manufacturer
Gemini
Hamlin/Regal
Jerrold/G. I.
Macom
Magnavox
Oak
Panasonic
Philips
Pioneer
Samsung
Scientific Atlanta
Tocom
Zenith
Operating a Cable Box or DBS Receiver
Code number
801 (preset code for
remote control)
802
802
Manufacturer code numbers
(DBS receiver)
Manufacturer
Sony
General Electric
RCA/PROSCAN
To operate the cable box or DBS
receiver
1
Press DBS/CABLE (POWER) (green
labeled button) to turn on/off the cable
box or DBS receiver.
2
Press DBS/CABLE (FUNCTION).
3
For other operations, refer to the
operating instructions that come with the
equipment.
If the remote control doesn’t work
• Try repeating the set up procedures using
the other codes listed for your equipment.
To operate the projection TV
Press TV (FUNCTION). Then use the
projection TV control buttons to control the
projection TV.
Tips z
• If more than one code number is listed, try entering
them one by one until you come to the correct code for
your equipment.
• If you enter a new code number, the code number you
previously entered at that setting is erased.
• In some rare cases, you may not be able to operate
your equipment with the supplied remote control. In
this case, use the equipment’s own remote control
unit.
• Whenever you remove the batteries — to replace
them, for example — if too much time is taken, the
code numbers may revert to the factory setting and
must be reset.
1 8 0
CODE SET ENTER DBS/CABLE
FUNCTION
Setting the Manufacturer's
Code
You can program the supplied remote
control to operate a cable box or DBS
receiver.
Press CODE SET, DBS/CABLE
(FUNCTION), and the 0-9 buttons to enter
the manufacturer’s code number (see the
following chart), then press ENTER.
For example, to operate a Sony DBS receiver:
Manufacturer code numbers
(cable box)
Code
233
222, 223, 224, 225, 226
201, 202, 203, 204, 205,
222, 206, 207, 208, 218
230, 231, 232
234
227, 228, 229
219, 220, 221
236, 237, 238, 239, 240, 241
214, 215
235
209, 210, 211
216, 217
212, 213