Switch, About the dtv i/o cable, Connecting a cable box – Sony KWP 65HD1 User Manual
Page 12: Cable box and cable, About the down converter switch
8
For this set up, you can switch between
scrambled channels (through your cable
box), and normal (CATV) channels by
pressing TV ANT on your remote control.
Notes:
• You may be able to program your Sony
remote control to operate your cable box.
(see “Operating a Cable Box or DBS
Receiver” on page 74)
• During PIP, P&P, CHANNEL INDEX or
FAVORITE CHANNEL viewing, the
AUX input can only be viewed in the
main picture.
• If you are connecting a cable box through
the AUX input and would like to switch
between the AUX and normal (CATV)
input, you should consider using
CHANNEL FIX.
(see “CHANNEL FIX” on page 56)
*Cable box
Cable
OUT
IN
(Rear of projection TV)
VHF/UHF
Select Cable or ANT mode by pressing TV
ANT on the remote control.
Connecting a cable box
Some pay cable TV systems use scrambled or
encoded signals that require a cable box* to
view all channels.
Note:
• If you will be controlling all channel
selection through your cable box, you
should consider using the CHANNEL
FIX feature. (see “CHANNEL FIX” on
page 56)
Cable box and cable
Some pay cable TV systems use scrambled or
encoded signals requiring a cable box* only for
certain channels (e.g. HBO, SHOWTIME, etc.)
*Cable box
VHF/UHF
(Rear of projection TV)
AUX
CATV cable
(unscrambled channels)
About the DOWN CONVERTER
switch
The DOWN CONVERTER switch on the
projection TV’s lower panel must be set to
OFF to receive an HD signal. Do not change
the switch position.
Note:
• If the DOWN CONVERTER switch is set
to ON, set the switch to OFF and turn off
the projection TV. Then, turn the power
back on to activate the new switch
position (OFF).
About the DTV I/O cable
The DTV I/O cable has already been
attached between the projection TV’s lower
panel and the DTV I/O connector on the
projection TV’s upper panel. Never touch,
tamper with, or disconnect the DTV I/O
cable from the connector, as this may cause
damage to the projection TV.
Installing and Connecting the Projection TV (continued)
S VIDEO
VIDEO
VIDEO OUT
3
Y
P
B
P
R
R
G
B
HD
VD
AUDIO OUT
L
(MONO)
DOWN
CONVERTER
1
2
4
1
2
OFF ON
DOLBY DIGITAL
OUTPUT
(OPTICALL)
R
CONTROL S
OUT
IN