Sony ZS-M30 - Manual (Page 26)

26 GB
Erasing recordings (Erase
Function) (continued)
Erasing all tracks on an MD
You can erase the disc name, all recorded
tracks and their names at the same time.
After you have erased all tracks on the MD,
you can use it as a new MD.
1
While the player is stopped, press EDIT
repeatedly until “All Erase” appears in
the display.
2
Press YES•ENTER.
“ALL Erase OK?” appears in the
display. Once you have erased tracks,
you cannot recover them. Be sure to
check the contents of the disc you are
trying to erase.
If you want to cancel the erase
function at this point:
Press NO•CANCEL or MD x.
3
Press YES•ENTER.
After “TOC EDIT” disappears from the
display, “Blank Disc” appears in the
display, and all contents on the MD are
erased.
3
Press YES•ENTER.
“Erase 003 OK?” appears in the display,
and one-track repeat play starts. Once
you have erased a track, you cannot
recover it. Be sure to check the contents
of the track you are trying to erase.
If you want to cancel the erase
function at this point:
Press NO•CANCEL or MD x.
4
Press YES•ENTER.
“Complete” appears in the display for a
few seconds, and the current track will
be erased.
Notes
• If “Protected” appears in the display, the tab on
the MD is in the record-protect position (page
45).
• After you stop editing,
do not disconnect the
mains lead or move the player while
“TOC EDIT” is flashing in the display.
If
you do so, editing may not be done properly.