Speco Technologies 8TH - Manual (Page 103)

User’s Manual
DVR-4TH/8TH/16TH Series
SPECO TECHNOLOGIES 07/10
102
5.4.4.1 Camera Select
This item is used to select a desired channel for setting the associated
parameters. Move the cursor to and press ENTER, then
select a channel using UP / DOWN keys. Press ENTER again to confirm the
setting.
5.4.4.2 Normal PPS
Normal PPS (Picture per Second) is used to set the recording rate for normal
status.
Please note that the total normal pps for all channels is limited under the
maximum PPS for each Record mode. To increase one channel’s pps, you
may have to reduce other’s first. Event pps is not restricted to this rule, since
a smart event scheduler will handle the total pps automatically.
5.4.4.3 Normal Qlty
This item is used to set the picture size for normal status recording. The
available options are listed as follow: , , , and
.
5.4.4.4 Event Max PPS
Event Max PPS is used to set the event recording rate for Event status.
Normally, the Event PPS is set to be equal to or greater than Normal PPS; the
setting depends on your application. If the Event PPS is set to <0>, the
DVR-4TH/ 8TH/ 16TH series unit stops recording event video during alarms.
5.4.4.5 Event Qlty
This item is used to set the picture size for event status recording. Refer to
previous section Normal Qlty for the available options.
5.4.4.6 Event Active
Users are allowed to choose which alarm type needs to be recorded. The
available options are (alarm events), (motion detection
events), (alarm event + motion detection), and (no events
active). The default setting is , which includes Alarm and Motion event
recording.