Swann P-6T4 - Manual (Page 9)

Digital Video Recorder User Manual
5
1 Power plug 2 Alarm in/alarm out
3 RS485 4 USB interface
5 LAN port 6 Audio in 1-2
7 S-video output 8 Audio output
9 Video output 10 Video in 1-4
Fig2.2 Back Panel
2.4 Remote Controller Introduction
2.4.1 Use Remote Controller
Notice: Please note that Remote Controller is not a standard part of this DVR. Your package might not include it.
Steps of using the Remote Controller are described as below:
STEP1 Put the battery into the Remote Controller.
1. Open the battery cover of the Remote Controller.
2. Put into two AAA batteries whose model is 7 and make sure that they are not inserted upside down.
3. Put back the battery cover.
STEP2 Check the followings if the Remote Controller does not work.
−
Whether the battery’s anode and cathode are in the correct position or not.
−
Whether the power of the battery is ran out or not.
−
Whether there is barrier between the Remote Controller and DVR or not.
−
Whether there are some signals which transmitted by other devices disturbing the Remote Controller or
not.
Notice: If the possibilities above are excluded, please contact with vendor to change the Remote Controller.