JVC CA-MXS6MD - Manual (Page 67)

– 64 –
English
3
Push the joy control downward ( ) — or upward
( ) — to select the source name.
• When the source is the external equipment connected
to the LINE 1 jacks:
You can select from “LINE1” (Initial setting),
“TAPE,” “DBS,” “VCR,” “TV,” and “GAME.”
• When the source is the equipment connected to the
LINE 2 jack:
You can select from “LINE2” (Initial setting) and
“P-MD” (portable MD player).
• When the source is the equipment connected to the
DIGITAL IN terminal:
You can select from “DIGITAL IN” (Initial setting)
and “DBS-DIGITAL.”
4
Press SET to finish the setting.
Auto Power Off Setting
Auto Power Off function automatically turns off the unit if
no sound comes in for more than 3 minutes.
If any operation is done during this 3-minute period, Auto
Power Off function is canceled temporarily even though no
sound comes in.
1
Press MENU.
The menu screen appears in the main display.
• If the unit is turned off, you cannot go to the next
step.
2
Push the joy control downward ( ) to select
“A.P.off (current setting*).”
* The current setting will appear following “A.P.off.”
3
Push the joy control rightward ( ) or leftward ( )
to select either “SET” or “CANCEL.”
SET : Activates the Auto Power Off function.
CANCEL : Cancels the Auto Power Off function.
4
Press SET to finish the setting.
When Auto Power Off function is activated, the A.P.off
indicator lights on the display.
The A.P.off indicator starts flashing if no sound comes
in.
When the remaining time until the shut-off time
becomes 20 seconds, it will be shown in the main
display.
3
Push the joy control downward ( ) — or upward
( ) — to select the input level
• When the source is the equipment connected to the
LINE 1 jacks:
Level 1 : Select when the recorded sound is not loud
enough. This setting increases the input
signal level. (Initial setting when shipped
from the factory)
Level 2: Select when the recorded sound is distorted.
This setting reduces the input signal level.
• When the source is the equipment connected to the
LINE 2 jack:
Level 1 : Initial setting when shipped from the
factory
Level 2: Select when the recorded sound is distorted
with “Level 1” selected.
Level 3: Select when the recorded sound is still
distorted with “Level 2” selected.
Level 4: Select when the recorded sound is still
distorted with “Level 3” selected.
• If “Level OVER!” still appears even after
setting the input level to “Level 4,” reconnect
the equipment to the LINE 1 jacks, and set the
input level to “Level 2.”
4
Press SET to finish the setting.
Changing the source name
You can change the external source names (LINE1, LINE2,
and DIGITAL IN) to the actual component names.
• You cannot change the external source names while
recording its sound on an MD.
1
Press MENU.
The menu screen appears in the main display.
• If the current source is not the external equipment
connected, you cannot go to the next step.
2
Push the joy control downward ( ) to select
“NAME CHANGE,” then press SET.
Ex. When the source is the external equipment
connected to the LINE 1 jacks
EN58-64.CA-MXS6MD[US/UB]/f 00.10.10, 9:56 AM 64