JVC CA-MXS6MD - Manual (Page 22)

– 19 –
English
3
Repeat steps 1 and 2 to store stations of the other
band.
When you cannot store stations you want
automatically
Stations with weak signals cannot be detected with this automatic
presetting method. To store such a station, use the manual
presetting method that follows.
To preset stations manually — Manual Presetting
1
Tune in the station you want to preset.
• See “Tuning in a Station” on page 18.
2
Press SET.
The preset number starts flashing.
3
Select a preset number.
On the remote control:
Press the number buttons.
Ex. For preset number 5, press 5.
For preset number 15, press +10, then 5.
For preset number 20, press +10, then 10.
On the unit:
Push the joy control rightward ( ) or leftward ( ).
• Rightward ( ): to increase the preset numbers.
• Leftward ( ): to decrease the preset numbers.
4
Press SET again.
The tuned station in step 1 is stored in the preset
number selected in step 3.
• Storing a new station on a used number erases the
previously stored one.
When you unplug the AC power cord or if a power
failure occurs
The preset stations will be erased in a few days. If this happens,
preset the stations again.
Tuning in a Preset Station
1
Press FM/AM.
The unit automatically turns on and tunes in the
previously tuned station (either FM or AM).
• Each time you press the button, the band alternates
between FM and AM.
2
Select a preset number.
On the remote control:
Press the number buttons.
Ex. For preset number 5, press 5.
For preset number 15, press +10, then 5.
For preset number 20, press +10, then 10.
On the unit:
Push the joy control rightward ( ) or leftward ( ).
• Rightward ( ): to increase the preset numbers.
• Leftward ( ): to decrease the preset numbers.
EN17-19.CA-MXS6MD[US/UB]/f 00.10.10, 9:43 AM 19