JVC CA-MXS6MD - Manual (Page 21)

– 18 –
English
Setting the AM Tuner Interval Spacing
Some countries space AM stations 9 kHz apart, and some
countries use 10 kHz spacing.
When shipped, the built-in AM tuner is set to 9 kHz
spacing.
On the unit ONLY:
To set the AM tuner to the 10 kHz spacing, be sure that
the unit is turned off, but is plugged into a wall outlet.
While holding the joy control upward (
), press .
To set it back to the 9 kHz spacing, be sure that the unit is
turned off, but is plugged into a wall outlet.
While holding the joy control downward (
), press .
When you change the setting
Preset stations will be erased. (You need to preset stations again.)
Tuning in a Station
1
Press FM/AM.
The unit automatically turns on and tunes in the
previously tuned station (either FM or AM).
• Each time you press the button, the band alternates
between FM and AM.
2
Tune into a station.
On the remote control:
Press and hold
¡ (¢) or 1 (4) until the
station frequencies start changing in the main
display.
•
¡ (¢) : to increase the frequencies.
•
1 (4) : to decrease the frequencies.
On the unit:
Push and hold the joy control upward (
) or
downward ( ) until the station frequencies start
changing in the main display.
• Upward (
): to increase the frequencies.
• Downward ( ): to decrease the frequencies.
The unit starts searching stations and stops when a
station of sufficient signal strength is tuned in (the
TUNED indicator lights).
• If an FM program is broadcast in stereo, the STEREO
indicator also lights.
To stop during searching, press
¡ (¢) or 1 (4)
(or push the joy control again on the unit).
When you repeatedly press ¡ ¡ ¡ ¡ ¡ (¢ ¢ ¢ ¢ ¢) or 1 1 1 1 1 (4 4 4 4 4)
(or push the joy control upward or downward on the
unit)
The frequency changes step by step.
When an FM stereo broadcast is hard to
receive or noisy
You can use the menu to improve FM reception.
See “FM Reception Mode Setting” on page 61.
Presetting Stations
You can preset 30 FM and 15 AM stations — using either
automatic presetting method or manual presetting method.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
To preset stations automatically — Automatic
Presetting
On the remote control ONLY:
You need to preset stations separately for the FM and AM
bands.
1
Press FM/AM to select the band.
2
Press and hold AUTO PRESET until “A. PRESET”
appears in the main display for about 2 seconds.
Local stations with strong signals are searched and
stored in memory automatically.
When automatic preset is over, the station stored in
preset number 1 is received.
Continued
EN17-19.CA-MXS6MD[US/UB]/f 00.10.10, 9:43 AM 18