JVC CA-MXS6MD - Manual (Page 45)

– 42 –
English
5
Press SET.
• If you have selected wrong tracks, press CANCEL,
then select the correct tracks.
6
Press ENTER/DEMO to finish the editing
procedure.
“EDITING” appears for a while, then “WRITING”
flashes while the editing you have made is being
recorded on the MD.
To divide the joined tracks, see the DIVIDE function.
If “CANNOT JOIN” appears in step 5
You cannot join the following tracks.
• Tracks recorded using different recording length modes (LONG
MODE — SP/LP2/LP4). (See page 33.)
• Digital-recording tracks and analog-recording tracks.
• Tracks recorded using monaural long recording method (not
possible on this unit) and stereo-recording tracks.
MOVE Function
This function allows you to move a track to the position
you prefer. It is useful to change the order of the tracks as
you like.
• To stop any time during editing process, press TITLE/
EDIT.
1
Insert an MD you want to edit into the MD loading
slot.
• It takes about 5 seconds for the unit to read the TOC
(Table Of Contents) of the inserted MD. While the
unit is reading it, you cannot go to the next step.
2
Press TITLE/EDIT.
The source is changed to “MD.”
• If “MOVE” is not shown, you cannot move the track.
JOIN Function
This function allows you to join two adjacent tracks into
one track.
• To stop any time during editing process, press TITLE/
EDIT.
1
Insert an MD you want to edit into the MD loading
slot.
• It takes about 5 seconds for the unit to read the TOC
(Table Of Contents) of the inserted MD. While the
unit is reading it, you cannot go to the next step.
2
Press TITLE/EDIT.
The source is changed to “MD.”
• If “JOIN” is not shown, you cannot join the tracks.
3
Push the joy control downward ( ) to select
“JOIN” (highlighted), then press SET.
4
Push the joy control downward ( ) or upward ( )
to select the two adjacent tracks you want to join.
Ex. When you want to join tracks 2 and 3
Continued
EN39-44.CA-MXS6MD[US/UB]/f 00.10.10, 9:50 AM 42