JVC CA-MXS6MD - Manual (Page 55)

– 52 –
English
There are three timers available — Recording Timer, Daily
Timer, and Sleep Timer.
Before using these timers, you need to set the clock built
in the unit.
To set the clock, Recording Timer and Daily Timer, you
have to use the menu. (See pages 59 and 60.)
Setting the Clock
You can set the clock whether the unit is turned on or in
standby mode.
On the unit ONLY:
1
Press MENU.
2
Push the joy control downward ( ) to select
“CLOCK SET” (highlighted), then press SET.
3
Push and hold the joy control rightward ( ) or
leftward ( ) to adjust the hour, then press SET.
• If you want to correct the hour after pressing SET,
press CANCEL. The hour digit starts flashing again.
The hour digit in the main display
starts flashing.
4
Push and hold the joy control rightward ( ) or
leftward ( ) to adjust the minute, then press SET.
“ADJUST OK!” appears in the main display, and the
built-in clock starts.
If there is a power failure
The clock loses the setting and is reset to “0:00.” You need to set
the clock again.
To adjust the clock again
Once you have adjusted the clock, you cannot go to the
clock setting directly on the menu.
To readjust the clock, follow the procedure below:
1 Press MENU.
2 Push the joy control downward (
) to select “REC
ON/OFF” (highlighted).
• If “REC ON/OFF” does not appear and “CLOCK
SET” appears, the clock setting has been lost. (In this
case, simply press SET in the following step.)
3 Push the joy control rightward ( ) or leftward ( ) to
select “CLOCK SET,” then press SET.
The hour digit starts flashing, and now you can adjust
the clock again, following steps 2 to 4 of “Setting the
Clock” procedure to the left.
Using Recording Timer
With Recording Timer, you can make an unattended
recording.
• You can set Recording Timer whether the unit is turned
on or in the standby mode.
• To correct a mis-entry any time during the setting
process, press CANCEL.
• To cancel the setting any time during the process, press
MENU.
How Recording Timer actually works
The unit automatically turns on, turns off the volume, and
starts recording on the MD when the timer-on time comes.
Then, when the timer-off time comes, the unit
automatically turns off (stands by).
Recording Timer works only once, but the timer settings
remain stored in memory until you reset them or unplug the
AC power cord.
Ex. When the unit is turned on, and the source
is CD (but not playing)
Continued
EN51-57.CA-MXS6MD[US/UB]/f 00.10.10, 9:54 AM 52