JVC RX-1024VBK - Manual (Page 9)

6
Connecting the Speakers
You can connect the following speakers:
•
Two pairs of front speakers to produce normal stereo sound.
• One pair of rear speakers to enjoy the surround effect.
• One center speaker to produce more effective surround effect (to emphasize human
voices).
• One subwoofer to enhance the bass.
IMPORTANT:
After connecting the speakers listed above, set the speaker setting information
properly to obtain the best possible performance. For details, see pages 18 and 19.
For each speaker (except for subwoofer), connect the (–) and (+) terminals on the
rear panel to the (–) and (+) terminals marked on the speakers. For connecting a
subwoofer, see page 7.
1 Cut, twist and remove the insulation at the end of each speaker signal cable.
2 Turn the knob counterclockwise.
3 Insert the speaker signal cable.
4 Turn the knob clockwise.
Connecting the front speakers
Connect the front speakers to the FRONT SPEAKERS terminals.
You can connect two pairs of front speakers (one pair to the FRONT SPEAKERS 1
terminals, and another pair to the FRONT SPEAKERS 2 terminals).
RIGHT
1
RIGHT
1
1 3 4
RIGHT
1
2
CAUTION:
Use speakers with the
SPEAKER IMPEDANCE
indicated by the speaker
terminals.
Note:
To obtain the best possible
output power from the receiver,
and to prevent the receiver from
being overheated, the receiver
has the SPEAKER LOAD
SELECTOR which has to be set
as follows:
• Set it to the HIGH position
when the impedance of the
speakers connected is within
the range of 8 ohms to 16
ohms.
• Set it to the LOW position
when the impedance of the
speakers connected is within
the range of 4 ohms to 6
ohms.
• Set it to the LOW position
when the impedance of the
any speaker connected is 6
ohms or less.
Right speaker Left speaker
SPEAKER
IMPEDANCE
/ OHMS
4 ~ 6
8 ~ 16
+ – + –
RIGHT LEFT
1
2
1
2
SPEAKER
LOAD
SELECTOR
LOW
HIGH
FRONT SPEAKERS
SPEAKER LOAD
POSITIONED LOW
SPEAKER LESS
EN01-12.RX-1024V[J]/1.PM5 98.5.12, 0:16 PM 6