JVC RX-1024VBK - Manual (Page 27)

24
5. Repeat steps 1 to 4 until you store all the stations you
want.
To erase a stored preset station
Storing a new station on a used number erases the previously stored one.
To tune in a preset station
On the front panel:
1. Press TUNER PRESET.
2. Turn MULTI JOG to select a preset channel.
From the remote control:
1. Press FM or AM.
2. Press 10 keys to select a preset channel number.
• For channel number 5, press 5.
• For channel number 15, press +10 then 5.
• For channel number 20, press +10 then 10.
• For channel number 30, press +10, +10, then 10.
Selecting the FM Reception Mode
When an FM stereo broadcast is hard to receive or noisy, set the FM reception mode to
“MONO.” (When shipped from the factory, this mode has been set to “AUTO.”)
You can change the FM reception mode while receiving an FM broadcast.
Press FM MODE on the front panel or FM MODE/
MUTE on the remote control.
Each time you press the button, the FM reception mode
alternates between “AUTO” and “MONO.”
AUTO: When a program is broadcast in stereo, you will hear stereo sound;
when in monaural, you will hear monaural sounds. This mode is
also useful to suppress static noise between stations.
The MUTE AUTO indicator lights up on the display.
MONO: Reception will be improved although you will lose the stereo effect.
In this mode, you will hear noise while tuning into the stations.
The MUTE AUTO indicator goes off on the display.
MULTI JOG
FM MODE
TUNER PRESET
Notes:
• You can store the FM
reception mode for each
preset station.
• When using the FM MODE/
MUTE button, be sure that the
10 keys are activated for
tuner, not for the CD and
others. (See page 58.)
Note:
When you use the 10 keys on
the remote control, be sure that
they are activated for tuner, not
for the CD and others. (See
page 58.)
AM FM
FM MODE/
MUTE
SUBWOOFER –
0
CNTR TONE CNTR – +
+10
100+
10
1 2 3
TEST REAR · L
REAR · R
– +
4 5 6
EFFECT
SEA MODE
RETURN FM MODE/
MUTE
– +
SUBWOOFER – +
7 /P 8
0
9
ENTER
MENU
EN23_27.RX-1024V[J]/1.PM5 98.5.12, 0:24 PM 24