JVC RX-1024VBK - Manual (Page 16)

13
Basic Operations
The following operations are commonly used when you play any sound source.
IMPORTANT:
When using the Remote Control, check to see if its remote control
mode selector is set to the correct position:
To operate an audio system, TV, and VCR, set it to “AUDIO/TV/
VCR.”
To operate a CATV converter, set it to “CATV.”
To operate a DBS tuner, set it to “DBS.”
Turning the Power On and Off
On the front panel:
To turn on the power, press POWER.
The STANDBY lamp goes off. The name of the current source (or
station frequency) appears on the display.
•
When the TV is connected to the TV SOUND/DBS jacks on the rear:
The receiver automatically turns on and select “TV SOUND” as the source about 5
seconds after you turn on the TV. (If you change the source name from “TV
SOUND” to “DBS,” the receiver will not turn on along with the TV. See page 17)
To turn off the power, press POWER again.
The STANDBY lamp lights up.
From the remote control:
To turn on the power, press AUDIO POWER.
The STANDBY lamp goes off. The name of the current source (or
station frequency) appears on the display.
To turn off the power, press AUDIO POWER again.
The STANDBY lamp lights up.
Selecting the Source to Play
On the front panel:
Turn SOURCE SELECTOR until the source name you want
appears on the display.
As you turn the selector, the source changes as follows:
The selected source lamp also lights up.
AUDIO/
TV/VCR
CATV
DBS
What are the following
indicators?
When you select the source
encoded with Dolby Digital and
start playback, the following
indicators light up on the display
to show the signal being input to
this receiver. (Only the indicators
for the received signals light up.)
L: Left front channel
R: Right front channel
C: Center channel
LS: Left rear channel
RS: Right rear channel
S:
Rear channel (monaural)
LFE: Subwoofer channel
S
C
DIGITAL
LS
L
LFE
RS
R
POWER
STANDBY
Note:
When connecting an MD
recorder (to the TAPE/MD
jacks), and a DBS tuner (to the
TV SOUND/DBS jacks), change
the source name appears on the
display. For details, see page
17.
POWER
AUDIO
POWER
STANDBY
FM
TV SOUND/DBS VIDEO
PHONO CD TAPE/MD AM DVD
VCR1 VCR2
CH–
CNTR
100 1k 10k
DIGITAL
MUTE AUTO
VOLUME
THEATER DRAMA
LIVE CLUB ACTION
DANCE CLUB
HALL HEADPHONE
PAVILION PRO LOGIC TUNED
STEREO
FR
LS
L
LEE
S
C D S P
3D-PHONC LOUDNESS
SLEEP ATT RS
R
S E A
Selected source name appears
Source lamps on the
front panel
DVD
TV SOUND/DBS PHONO
TAPE/MD VCR 1
VCR 2 FM
AM VIDEO
CD
SOURCE SELECTOR
Current source name appears
100 1k 10k
VOLUME
FR
Current volume level
is shown here
Note:
When you turn off the receiver
with the TV kept turned on, the
receiver will turn on soon again.
To prevent this from happening,
make sure that you turn off the
TV before turning off the
receiver.
EN13_22.RX-1024V[J]/1.PM5 98.5.12, 0:18 PM 13