JVC RX-1024VBK - Manual (Page 3)

G-2
To get the best DSP (Digital Signal Processor) effect in your listening room, note the speaker
settings you have set on the table below for future reference (even though the receiver
memorizes the settings until you change them).
For actual setting procedures, see pages 19 to 21.
Speakers Setting
Front Speakers LARGE SMALL
Center Speaker LARGE SMALL NONE
Rear Speaker LARGE SMALL NONE
Center Delay Set to [ msec] (Select from 0 to 5 msec)
Rear Delay Set to [ msec] (Select from 0 to 15 msec)
Crossover Frequency 80 Hz 100 Hz 120 Hz
LFE Attenuator 0 dB 10 dB
Dynamic Range Compression OFF MID MAX
Note:
If the power cord is unplugged
or a power failure occurs, all
preset settings will be erased in
a few days.
Warranty.RX-1024V[J]/1.PM5 98.5.12, 0:45 PM 2