Jensen MP8610BT - Manual (Page 52)

MP8610BT
52
Phone book - H/P searching date from H/P
Phone Book-H/P phone book Empty
Phone Book-Moblie
Phone Book-H/P phone book No Information
Phone Book-Card
Phone Book-Card phone book Empty
Phone book - H/P searching date from Card
Phone Book-card phone book No Information
Bluetooth Operation (continued)
Telephone Menu (TEL-MENU) (continued)
Speed Dial (continued)
Previewing the Speed Dial List
Press the TEL-MENU button (28) three times to display the “Speed Dial List” .
• Use the up (+) or down (-) joystick buttons to navigate through the 10 Speed Dial numbers
on the list.
• Press either the AUDIO button (4) or the PHONE button (25) to dial the number selected
from the list.
Clearing the Speed Dial List
Select the number you want to delete from the list, press and hold the CLEAR button (26) for
more than 3 seconds to remove the number.
Editing the Speed Dial List
Select the number you want to edit from the list, then press the AUDIO button (4) to enter the
editing interface.
Phone Book (Mobile/SIM Card)
1. Press the TEL-MENU button (28) four times to display “Phone book on Mobile” on the
LCD or five times to display “Phone Book on SIM Card” on the LCD. The LCD will display
“Reading” while downloading the data from the mobile phone.
2. Once the download is completed, you can use the up (+) or down (-) joystick buttons to
navigate through the list. One phone book entry is downloaded at a time.
3. Press the up (+) or down (-) joystick buttons to download the next entry.
4. Press either the AUDIO button (4) or the PHONE button (25) to dial the number selected
from the list.
NOTE: Some mobile phones, like Nokia, do not support Phone Book upload through
Bluetooth. In this case, the LCD Display will display “ No Info”.
Auto Answer
Press the TEL-MENU button (28) six times to access the “Auto Answer” function. The default
setting is “off”.
• If “Off” is selected, you must press the PHONE button (25) to answer an incoming call.
• If “On” is selected, the unit will automatically answer the incoming call after three seconds.
Incoming Call Ringing Volume
Press the TEL-MENU button (28) seven times to access the “Ringing Volume Level” function.
You can pre-set the Ringing Volume level for any incoming call.
The default Ringing Volume level is “20”. Press the up (+) or down (-) joystick buttons to adjust
the level from a minimum of “00” to a maximum of “38”.
Incoming Call Blinking Mode
Press the TEL-MENU button (28) eight times to access the “Incoming call backlight on/off”
function. The default setting is “off”. When “On” is selected, there is no ring tone for incoming
calls – the LCD backlight will blink when a call comes in.