Jensen MP8610BT - Manual (Page 10)

MP8610BT
10
Installation
Final Installation
1. Connect wiring adapter to existing wiring harness.
2. Connect antenna lead.
3. Slide radio chassis into half-sleeve.
4. Secure radio to bracket using nut (if possible).
5. Replace any items you removed from the dashboard.
Final ISO-DIN Installation
Install the unit using the screw holes on the sides of the unit.
1. Remove trim ring.
2. Mount factory brackets on new radio using existing screws from old radio.
3. Slide radio chassis into dash opening and secure.
4. Reinstall dash panel.
NOTE: The mounting box, outer trim rin, and half-sleeve are not used for this type of
installation.
Remove Radio from Dash
To remove the radio from the dash, detach the front panel and remove the trim ring by gently
pulling up in the middle to release the plastic snaps. Insert removal keys between the radio
chassis and sleeve to depress locking springs. Pull the radio out of the dash.
2
1
3
4
MP8610B T
PHONE
AS/PS
MP3/W MA RECEIV ER
/ PT M
MOSFE T 72 WATTS
1
2
3
4
5
MP861 0BT
PHONE
AS/PS
MP3/W MA RECEIV ER
/ PT M
MOSFE T72 WATTS
/
Final Installation
Instalación Finale
Installation Finale
Final ISO-DIN Installation
Instalación Finale ISO-DIN
Installation Finale
ISO-DIN
Remove Radio from Dashl
Extracción del Radio del Automóvil
Retrait de la radio du tableau de bord