JVC YU30052-625-1 - Manual (Page 65)

EN
65
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
13. Digital Zoom doesn’t
work.
14. P.AE/Effects and Fade/
Wipe Effects don’t work.
15. The Black & White Fader
doesn’t work.
16. The Dissolve function
doesn’t work.
17. The Picture Wipe and
Dissolve functions don’t
work.
13. •10x optical zoom is selected.
•The Video Echo effect is activated.
•Picture Wipe or Dissolve
are being used in a scene
transition.
•5-Second recording was
done with the Power Dial
set to “5S”, and with “5SD”
selected in the System Menu.
•Snapshot Dissolve was
attempted during Digital
Zoom.
14. •The Select Dial is set to
“AUTO”.
•The Power Dial is set to
“5S”.
15. •The Sepia or Monotone
effects are activated.
16. •P.AE/Effects Sepia,
Monotone or Slow are
activated.
•The Squeeze mode is
selected.
17. •The last selected editing
scene is ending.
•At the end of the last
selected scene for editing,
the Power Dial was set to
“OFF”.
•The power is off.
•The previously selected
P.AE/Effect was changed
after the last selected scene
for editing was registered.
•The P.AE/Effects in the
Recording Menu were
exchanged after the last
selected scene for editing
was registered.
13. •Turn off the Video Echo
effect (
੬
pg. 33).
•Wait until the Picture Wipe
or Dissolve effects are
completed.
•Change the setting of either
the System Menu or the
Power Dial (
੬
pgs. 18, 19).
•Do not attempt to take a
Snapshot when performing
Digital Zoom (
੬
pg. 22).
14. •Set the Select Dial to
“MANUAL”.
•Change the setting of the
Power Dial.
15. •Turn off Sepia and
Monotone (
੬
pg. 33).
16. •Turn off Sepia and
Monotone before adding
Dissolve to a scene
transition (
੬
pg. 33).
•Make sure that the Squeeze
mode in the Recording
Menu is set to “OFF”.
17. •Select Picture Wipe or
Dissolve before beginning
recording. The effects are
then automatically
activated (
੬
pg. 30).
•Do not turn off the
camcorder’s power after
setting Edit-In and Edit-Out
points, as they will all be
erased.
•The camcorder
automatically shuts off
after 5 minutes have
elapsed in the RECORD/
STANDBY mode. Make
sure you continue
operations within
5 minutes after engaging
RECORD/STANDBY.
•Make sure you have
selected the P.AE/Effects
you want before starting
editing.
•Exchanging P.AE/Effects
may deactivate the effect(s)
you selected. Once you’ve
selected an effect, do not
perform an exchange
before beginning editing. If
you do, make sure you
don’t replace the effect(s)
you selected.