JVC YU30052-625-1 - Manual (Page 52)

52
EN
EDITING (Cont.)
1
2
3
4
5
6
7
8
T I ME CODE
TOTAL
00 : 0 0
~
~
~
~
~
~
~
~
I N OUT MODE
: :
:
T W
NOTES:
● When choosing a scene, set Edit-In and Edit-Out
points so there’s a relatively large difference
between them.
● If the search time for an in-point exceeds
5 minutes, the recording deck's Record-Standby
mode will be cancelled and editing will not take
place.
● If there are blank portions before or after the
Edit-In and Edit-Out points, a blue-backed screen
may be included in the edited version.
● Since time codes register time only as accurately
as seconds, the time code total time may not
match the total program time exactly.
● Turning off the camcorder’s power erases all
registered Edit-In and Edit-Out points.
● To use a P. AE/Effect, press EFFECT on the remote
control repeatedly to cycle through the effects
until the one you want is displayed.
● To change previously registered points, press
CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
● If you use Sepia or Monotone P.AE/Effects, you
can’t use the Dissolve or Black & White Fader. In
this case the Dissolve or Black & White indicator
begins blinking. Once the next Edit-In point is
registered, the effect is turned off. To combine
these effects, use Sepia or Monotone during
recording, then use Dissolve or Black & White
Fader during Random Assemble Editing.
POWER DIAL
REMOTE SENSOR
PROGRAM
RANDOM ASSEMBLE
EDITING MENU
4 SET EDIT-IN POINT
At the beginning of the scene, press EDIT IN/
OUT on the remote control. The Edit In
position appears in the viewfinder and on the
connected TV.
5 SET EDIT-OUT POINT
At the end of the scene, press EDIT IN/OUT.
The Edit Out position appears in the viewfinder
and on the connected TV.
6 USE FADE WIPE ON SCENE
TRANSITION
Press FADE/WIPE.
• Cycle through the effects by pressing
repeatedly, and stop when the one you want
is displayed.
• If you select a Fade/Wipe effect for an
Edit-Out point, the effect is automatically
applied to the following Edit-In point.
• When you use Fade/Wipe effects, that time is
included in the total time (this does not apply
to Picture Wipe/Dissolve).
7 USE P.AE/EFFECT
Press EFFECT.
• Cycle through the effects by pressing
repeatedly, and stop when the one you want
is displayed.
• You can use Classic Film, Monotone, Sepia,
Strobe or Video Echo effects.
8 CONTINUE EDITING
Repeat steps 4 – 7.
• If you're not using Fade/Wipe or P.AE/Effects,
repeat steps 4 and 5 only.
PLAY
R.A.EDIT ON/OFF
FADE/WIPE
EDIT IN/OUT
EFFECT
CANCEL
RM-V708U (provided)