JVC YU30052-625-1 - Manual (Page 19)

EN
19
Beep
The beep sounds when the power is turned on or
off, and at the beginning and end of recording.
ON–To activate the beep.
OFF–To turn off the beep.
NOTE:
Beep is automatically turned on during Full Auto
operation.
Wind Cut
When activated, this mode helps cut down on noise
created by wind.
AUTO–When shooting in high winds, noise is
automatically reduced.
•“
” appears in the viewfinder.
•The quality of the sound will change. This is
normal.
OFF–This function is disabled.
NOTE:
The Wind Cut mode is disabled during Full Auto
operation.
SCENE
BEEP
W IND CUT
SOUND MODE
I D No .
END
5 S
ON
OFF
4 8 kHz
0 7
I T EM ZOOM SW .
SET SET BUTTON
Sound
Sound signals can be sampled at 48 kHz or 32 kHz.
48 kHz–The camcorder is factory-preset for 48 kHz.
This setting enables recording of stereo sound on
two separate channels. *A tape recorded at 48 kHz
cannot be used for Audio Dubbing.
32 kHz–This setting enables recording of stereo
sound on four separate channels, and is
recommended for use when performing Audio
Dubbing.
Scene (5-Second Mode)
This mode is enabled when the Power Dial is set to
“5S”.
5S–Pressing RECORDING START/STOP allows you
to take a 5-second “clip”. Press repeatedly for a
succession of short recordings.
5SD–If you record a 5-second clip within 5 minutes
after the previous one, the end of the old scene
dissolves and is replaced by the new scene over a
2-second period (
੬
pg. 24).
ANIM. (Animation)–Each time you press
RECORDING START/STOP, a 1/8-second recording
is taken. By using an inanimate object and changing
its position between shots, you can record the
subject as though it’s moving.
5S
5SD
ANIM.
ON
OFF
OFF
AUTO
48 kHz
32 kHz
This number will be necessary in the future
when connecting the camcorder to a
computer [01 to 99].