JVC YU30052-625-1 - Manual (Page 57)

EN
57
6w
T W
12:34
Insert Editing
You can insert snapshots and other scenes in previously recorded footage.
DISPLAY
PLAY
PAUSE
INSERT
REW(IND)
RM-V708U (provided)
RECORDING START/STOP
REMOTE SENSOR
POWER DIAL
4 START RECORDING
Press RECORDING START/STOP to begin
editing.
•Confirm the insert at the time code you
checked in step 1.
5 PAUSE DURING EDITING
Press RECORDING START/STOP. Press again
to resume editing.
6 STOP EDITING
Press RECORDING START/STOP, then press
STOP.
NOTES:
● When performing Insert Editing, the tape’s Video
Area and Sub-Code Area (
੬
pg. 4) are rewritten,
so the date and time information changes.
● If you perform Insert Editing onto a blank space
on the tape, the audio and video may be
disrupted. Make sure you only edit recorded
areas.
1 FIND EDIT OUT POINT
Confirm the time code at this point.
(
੬
pg. 45)
2 FIND EDIT IN POINT
Press REW until the point is located, then press
PAUSE.
3 PREPARE FOR INSERT EDITING
Press and hold INSERT on the remote control,
then press PAUSE. “6w” and the Time Code
(min.:sec.) appear in the viewfinder.
NOTE:
To see the on-screen characters on a connected TV,
press DISPLAY on the remote control.
(
੬
pg. 49)
Place photo, etc.
on its side.