beautypg.com

Preset download, Attention – JVC HM-DR10000EK User Manual

Page 9

background image

9

PRESET DOWNLOAD

SET THE TUNER CHANNELS BY DOWNLOADING FROM YOUR TV, CLOCK AND GUIDE PROGRAM
NUMBERS

When you connect the recorder and your TV via fully-wired 21-pin SCART cable (

pg. 6), you can set the recorder's tuner channels

by downloading preset data from your TV instead of using the Auto Set Up function (

pg. 8). After downloading is completed, the

recorder sets the clock and Guide Program numbers assigned by the VIDEO Plus+ system automatically.
For details, refer to the instruction manual for your TV.

NOTES:

In areas where no TV station transmits the PDC signal, the recorder cannot perform either auto clock set or auto Guide Program
number set.

If there is a power cut, or if you press

or MENU while downloading or set up is in progress, it will be interrupted; be sure to

turn off the recorder power once and try again from the beginning.

Auto clock may not function properly depending on reception conditions.

When you perform T-V LINK function, be sure to use fully-wired 21-pin SCART cable.

On this recorder, the characters available for station names (ID) are A–Z, 0–9, –,

*

, + and (space). The names of some

downloaded stations may differ from those on your TV (

pg. 62).

ATTENTION

You can use this function only with a TV offering T-V Link, etc.*

* Compatible with TVs offering T-V Link, EasyLink, Megalogic, SMARTLINK, Q-Link, DATA LOGIC or NEXTVIEWLINK via fully-wired 21-pin

SCART cable. The degree of compatibility and available functions may differ by system.

Before performing the following procedure, make sure that:

Ⅲ the TV aerial cable is connected to the recorder and a 21-pin SCART cable is connected between your TV and the recorder.

Ⅲ the mains power cord is plugged into the mains outlet.

Ⅲ batteries have been installed in the remote control.

2

If "Auto" appears on the display panel,
Press

%fi to select "CH – –" and press OK

or

#

. Preset position on the display panel

increases from "CH1";
do NOT press any button on the recorder
or remote control until the display panel
shows clock time, "(PR) 1" or
"– –:– –" as illustrated on page 10.

● If you are using the on-screen display, the T-V

LINK screen will appear. Then the GUIDE
PROG SET screen will appear during Guide
Program number set.

● If you press any button on the recorder or

remote control while downloading is in
progress, this process will be interrupted and
you will need to start again. See NOTES below.

T-V LINK

PLEASE WAIT

[MENU] : EXIT

GUIDE PROG SET

PLEASE WAIT

[MENU] : EXIT

1

2

3

4

5

6

7

8

9

1

2

1

2

3

– –:– –

0

3

4

4

1

Press

to turn on the recorder.