JVC HM-DR10000EK - Manual (Page 15)

15
LOAD A CASSETTE
1
Insert a cassette with the record safety tab intact.
● The counter is reset to 0:00:00 and the recorder
power comes on automatically.
CHOOSE A PROGRAMME
2
Press TV PROG +/– or the NUMBER keys to select the
channel you wish to record.
● The TV PROG dial can also be used to select a
channel.
SET TAPE SPEED
3
Press SP/LP ( ). Check the SP/LP indicator on the
front display panel to confirm the selected tape speed.
START RECORDING
4
Press and hold RECORD and press PLAY on the remote
control, or press RECORD on the recorder.
● You can not change the preset whilst recording is in
progress. To change the preset, see step 5.
PAUSE/RESUME
RECORDING
5
Press PAUSE. Press PLAY to resume recording.
● During the Record Pause mode, you can change the
preset by pressing the TV PROG +/– buttons or the
NUMBER keys.
STOP RECORDING
6
Press STOP. Then press EJECT to remove the cassette.
S-VHS/VHS Recording Compatibility Of Cassettes And
Recording Mode
Cassette
Recording Mode
D-VHS S-VHS VHS
D-VHS Yes Yes Yes
S-VHS No Yes Yes
VHS No No Yes
NOTES:
● The D-VHS (MTP), S-VHS and VHS mode recordings are
possible with this recorder.
● To record in the D-VHS mode, use a D-VHS cassette.
● To record in the S-VHS mode, you can use a S-VHS or D-
VHS cassette.
● To record in the VHS mode, you can use a VHS, S-VHS or
D-VHS cassette.
B.E.S.T. takes place at the beginning of both the
first SP and the first LP recording after inserting the
cassette (
੬
pg. 34).
If "DIRECT REC" is set to "ON", the programme
that appears on the TV screen will be recorded
(
੬
pg. 11).
Accidental erasure prevention
● To prevent accidental recording on a recorded cassette,
remove its safety tab. To record on it later, cover the hole
with adhesive tape.
Record safety tab
INFORMATION
When using the AV connection (
੬
pg. 6), you can switch
between TV mode and AV mode by pressing TV/VCR.
* Depending on the type of TV used, TV/VCR button does
not function as described above.