JVC HM-DR10000EK - Manual (Page 18)

18
ACCESS VIDEO PLUS+ DISPLAY
1
Press LCD PROG.
The LCD panel looks like this:
ENTER PLUSCODE NUMBER
2
Press the NUMBER keys to enter the PlusCode number of
a programme you wish to record, then press .
● If you make a mistake, press and input the correct
number.
The PlusCode number you enter appears on the LCD panel:
Then go to step 3 in the right column.
1 2 3
4 5 6
7 8 9
1
2
1
2
3
– –:– –
0
3
4
4
VIDEO Plus+ ®
Timer Programming
Before performing the VIDEO Plus+ Timer Programming:
● Make sure that the recorder's built-in clock is set properly.
● Insert a cassette with the safety tab in place. The recorder
will come on automatically.
● Set the appropriate recording mode (D-VHS, S-VHS or
VHS) (
੬
pg. 14, 15).
● Turn on the TV and select the AV mode.
BASIC OPERATIONS (cont.)
OK
2
2,6
PROG
1,6
NUMBER
5
2
PDC
7
WEEKLY DAILY
LCD panel
1
LCD PROG
You can use the remote control with LCD panel to enter the
PlusCode number.
4
With the VIDEO Plus+ system, timer programming is greatly
simplified because each TV programme has a corresponding
code number which your recorder is able to recognise.
SP
– P1 –
VIDEO PLUS+ 123456789
START STOP
21:00 = 22:00
SP(STD) VPS/PDC OFF
DATE TV PROG
25.12 1
BBC 1
: OK
V I D E O P L U S +
[0 – 9] : VIDEO PLUS+
[+/–] : EXPRESS PROGRAMING
[PROG] : EXIT
V I D E O P L U S +
1 2 3 4 5 6 7 8
[0 – 9] =
[ ] : DELETE
[PROG] : EXIT
TIMER
‰ TIMER indicator
STD/LS3 (SP/LP)
STOP+/–
ACCESS VIDEO PLUS+ SCREEN
1
Press PROG.
The front display panel looks like this:
ENTER PLUSCODE NUMBER
2
Press the NUMBER keys to
enter the PlusCode number
of the programme you
wish to record, then press
OK.
● If you make a mistake,
press and input the
correct number.
The PlusCode number you enter appears on the front
display panel:
The display panel shows only a 4-digit number.
ACCESS VIDEO PLUS+ PROGRAM
SCREEN
3
The VIDEO Plus+ Program
screen appears (if you’re
just starting out, “P1”
appears).
The display panel shows the
programme start time.
Pressing
changes the
display to the programme
stop time, then the date and
preset position.
IMPORTANT
Make sure the preset position number you wish to
record is displayed; if not, see "VIDEO Plus+
®
Setup" on page 65 and set the Guide Program
number for that PlusCode number correctly.
● If the number you entered is invalid, "ERROR" appears
on the screen and "Err" appears on the display panel.
Press and input a valid PlusCode number.
● If the "GUIDE PROG SET" screen appears, see
"ATTENTION – Regarding Guide Program Number
Set" on page 19.