JVC HM-DR10000EK - Manual (Page 48)

48
MAKE CONNECTIONS
1
Connect the player’s 21-pin SCART connector to the
recorder’s 21-pin SCART connector as illustrated on
page 49.
A
When Using Your Video Recorder As The Source
Player ...
... connect its AV1 IN/OUT connector to the
recording deck.
B When Using Your Video Recorder As The Recording
Deck ...
... connect its AV2 IN/DECODER or AV1 IN/OUT
connector to the source player.
C If Another Recorder Is Compatible With The Y/C
Signal ...
... connect your recorder 's AV1 IN/OUT connector to
another recorder.
With C connection ...
● When using your recorder as the recording deck, set
"AV1 SELECT" to "S-VIDEO" and "AV2 SELECT" to
"AV2" (
੬
pg. 50).
● When using your recorder as the source player, set
the AV1 OUT switch on the rear panel to Y/C
(
੬
pg. 6).
SET RECORDING MODE
2
Set the appropriate recording mode (D-VHS, S-VHS or
VHS) (
੬
pg. 14, 15, 32, 33).
SET RECORDING DECK’S
INPUT MODE
3
Set to AUX. With this video recorder, press NUMBER
key "0" and/or TV PROG to select “L-1” for the AV1 IN/
OUT connector, or “L-2” for the AV2 IN/DECODER
connector, depending on the connector being used.
● When using the AV2 IN/DECODER connector, set
"AV2 SELECT" to the appropriate mode. (
੬
pg. 50)
SET EDIT MODE (S-VHS/
VHS MODE ONLY)
4
See "Picture Control" on page 45.
START SOURCE PLAYER
5
Engage its Play mode.
START RECORDING DECK
6
Engage its Record mode.
ADVANCED OPERATIONS (cont.)
Edit To Or
From Another
Video
Recorder
You can use your video recorder as the source player or as the
recording deck.
1 2 3
4 5 6
7 8 9
1
2
1
2
3
– –:– –
0
3
4
4
NUMBER "0"
TV PROG