JVC HM-DR10000EK - Manual (Page 14)

14
TV signals being received by the recorder’s built-in tuner can be
recorded onto a video tape. You can “capture” a TV programme
using your video recorder.
BASIC OPERATIONS (cont.)
Recording
● Turn on the TV and select the AV mode.
● Insert a D-VHS cassette to record in the D-VHS mode.
LOAD A CASSETTE
1
Insert a cassette with the record safety tab intact (See
next page).
● The counter is reset to 0:00:00 and the recorder
power comes on automatically.
● While "– – – –" is blinking on the front display panel,
the tape will run for a few seconds to search for the
tape number.
● The STD (or LS3) indicator lights and the D-VHS
recording mode is selected automatically.
CHOOSE A PROGRAMME
2
Press TV PROG +/– or the NUMBER keys to select the
preset you wish to record.
● The TV PROG dial can also be used to select a
channel.
SET TAPE SPEED
3
Press STD/LS3 ( ). Check the STD or LS3 indicator
to confirm the selected tape speed.
START RECORDING
4
Press and hold RECORD and press PLAY on the remote
control, or press RECORD on the recorder.
● You can not change the preset whilst recording is in
progress. To change the preset, see step 5.
PAUSE/RESUME
RECORDING
5
Press PAUSE. Press PLAY to resume recording.
● During the Record Pause mode, you can change the
preset by pressing the TV PROG +/– buttons or the
NUMBER keys.
STOP RECORDING
6
Press STOP. Then press EJECT to remove the cassette.
6
2
6
TV PROG
If "DIRECT REC" is set to "ON", the programme
that appears on the TV screen will be recorded
(
੬
pg. 11).
D-VHS Recording
NOTE:
To record in the S-VHS or VHS mode on a D-VHS cassette,
press D-VHS so that the STD (or LS3) indicator goes off (
੬
pg.
32).
3
4,5
1 2 3
4 5 6
7 8 9
2
1
2
3
0
3
4
4
RECORD
4 PAUSE
5
NUMBER
2
PLAY
TV PROG
2
STOP
EJECT STOP
STD/LS3 (SP/LP)
4
2
5
3
TV PROG
D-VHS
PLAY
RECORD
5 STD/LS3 (SP/LP)
PAUSE
STD indicator LS3 indicator
6