JVC HM-DR10000EK - Manual (Page 52)

52
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS INITIAL SET
SCREEN
2
Press
%fi to move the highlight bar (pointer) to
"INITIAL SET", then press OK or
#
.
ACCESS JLIP ID NO. SET
SCREEN
3
Press %fi and move the
highlight bar (pointer) to
"JLIP ID NO. SET", then
press OK or
#
.
SET JLIP ID NUMBER
4
Press NUMBER keys to
enter the desired ID
number.
RETURN TO NORMAL
SCREEN
5
Press OK.
Information
On J Terminal
J Terminal (JLIP (Joint Level
Interface Protocol) Connector)
The J Terminal is used to connect the recorder to a personal
computer or similar device to allow computerized control of the
recorder during editing and certain other operations.
Example:
With the optional JLIP VIDEO CAPTURE BOX GV-CB3E:
● Allows you to capture still images from the recorder into a
personal computer.
For further details consult your nearest JVC dealer.
JLIP ID Number
Your recorder has its own JLIP ID number. This ID number must
be unique when your recorder is connected to another device
via its J terminal. The ID Number is preset to "1" at the factory.
You can change this number to any number between "1" and
"99". If it is necessary to change the JLIP ID number perform the
following steps.
J terminal
ADVANCED OPERATIONS (cont.)
1 2 3
4 5 6
7 8 9
1
2
1
2
3
– –:– –
0
3
4
4
OK
NUMBER
MENU
INTIAL SET
CLOCK SET
GUIDE PROG SET
JLIP ID NO. SET
[ 5∞] =
[MENU] : EXIT
JLIP ID NO. SET
1
CLOCK SET
[0-9] =
[MENU] : EXIT