Juniper Networks T1600 - Manual (Page 35)

Verifying Operation
Use the following commands to verify proper operation of the T1600 routing node:
1. Verify that the model number is now T1600 by issuing the show version
command.
user@host> show version
Hostname: myhost
Model: t1600
JUNOS Base OS boot [8.5R1]
JUNOS Base OS Software Suite [8.5R1]
JUNOS Kernel Software Suite [8.5R1]
JUNOS Crypto Software Suite [8.5R1]
JUNOS Packet Forwarding Engine Support (M/T Common) [8.5R1] JUNOS Packet Forwarding Engine Support
(T-Series) [8.5R1] JUNOS Online Documentation [8.5R1] JUNOS Routing Software Suite [8.5R1]
2. Verify that no alarms are present by issuing the show chassis alarms command.
user@host> show chassis alarms
No alarms currently active
3. Verify that the LEDs and indicators on the craft interface show that the routing
node is operating properly by issuing the
show chassis craft-interface command.
user@host> show chassis craft-interface
FPM Display contents:
+--------------------+
|Myhost router |
|Up: 0+22:34 |
| |
|Temperature OK |
+--------------------|
Front Panel System LEDs:
Routing Engine 0 1
--------------------------
OK * *
Fail . .
Master * .
Front Panel Alarm Indicators:
-----------------------------
Red LED .
Yellow LED .
Major relay .
Minor relay .
Front Panel FPC LEDs:
FPC 0 1 2 3 4 5 6 7
------------------------------------
Red . . . . . . . .
Green * * * * * * * *
CB LEDs:
Upgrading SIBs ■ 35
Upgrading SIBs