Juniper Networks T1600 - Manual (Page 24)

Figure 16: Three-Input 240-A Power Supply with the Optional Cable Restraint
To replace the cable restraint on a three-input 240-A power supply, use the following
procedures:
■ Removing the Standard Cable Restraint from a Three-Input 240-A Power
Supply on page 24
■ Installing the Optional Cable Restraint on a Three-Input 240-A Power
Supply on page 24
Removing the Standard Cable Restraint from a Three-Input 240-A Power
Supply
The cable restraint is located on the right edge of the power supply faceplate. To
remove the standard cable restraint, follow this procedure:
1. Loosen the captive screw on the standard cable restraint.
2. Remove the cable restraint from the power supply.
Installing the Optional Cable Restraint on a Three-Input 240-A Power Supply
To install the optional cable restraint, follow this procedure:
1. Align the two captive screws on the optional cable restraint with the two threaded
holes located at the right edge of the power supply faceplate.
2. Fasten the captive screws.
24 ■ Upgrading the DC Power Supplies
T1600 Routing Node Upgrade Guide