JVC Everio GZ-MG255U - Manual (Page 51)

51
ENGLISH
The camera is a microcomputer-controlled
device. External noise and interference (from
a TV, a radio, etc.) might prevent it from
functioning properly.
The following phenomena are not
malfunctions.
• The camera heats up when it is used for a
long time.
• The battery heats up during charging.
• When playing back a video fi le, the
image stops momentarily or the sound is
interrupted at junctions between scenes.
• To solve the problem, fi rst follow the
instructions below.
• If the problem is not solved, reset the
camera. ( ੬ below)
• If the problem persists, please consult your
nearest JVC dealer.
8 To reset the camera
1) Set the power/mode switch to OFF and
remove the power supply (battery pack
or AC adapter) from the camera, then
reattach it.
2) Execute [PRESET] from the menu.
( ੬ pg. 49)
Trouble Action ੬
P
o
wer
No power is supplied.
• Connect the AC adapter securely.
• Detach the battery pack once again and re-attach it fi rmly.
• Replace the dead battery with a fully charged one.
12
12
–
No display appears.
• If the camera is not operated for 5 minutes while
the power is on, it turns itself off automatically to
conserve power.
To turn the camera on again when
using the battery pack, set the power/mode switch to
OFF, then to ON. When using the AC adapter, perform
any operation such as zooming.
• Adjust the brightness of the LCD monitor.
–
48
The power was turned
off accidentally.
• Move to a place where no vibration or excessive sound.
• The drop detection function operated. Set the power/
mode switch to OFF, and to ON again. To turn off this
function, set [DROP DETECTION] to [OFF].
–
48
The displayed amount
of remaining battery
power differs from the
actual operating time. • Fully charge the battery, and then run it down. If the
problem persists, the battery is worn out and needs to be
replaced. Please purchase a new one.
12
The power does not
turn on, or the battery
operation time is
extremely short even
after the battery is
fully charged. • Make sure to use the camera under appropriate operating
temperatures.
• The battery is worn out and needs to be replaced. Please
purchase a new one.
55
–
The access/charge
lamp on the camera
does not light during
charging.
• Charging is diffi cult in places subject to extremely
high/low temperatures. To protect the battery, it is
recommended to charge it in places with a temperature
of 10°C to 35°C (50°F to 95°F).
• When the battery is already fully charged, the lamp does
not light. Check the remaining battery power.
–
14
Troubleshooting