John Deere AUTOTRAC OMPFP11320 - Manual (Page 27)

GS2 Display 1800
CF86321,000038D -19-01JUN11-1/1
CF86321,000038E -19-01JUN11-1/1
CF86321,000038F -19-01JUN11-1/1
Automatic Guidance System Detected
Each time a machine equipped with AutoTrac is started,
this screen will appear as a reminder of operator
responsibilities when using AutoTrac steering system.
PC13157
—19—17FEB1
1
Automatic Guidance
Enabling System
Press STEER ON/OFF button to toggle between
enable/disable AutoTrac.
To enable system, all of the following criteria must be met:
• AutoTrac activation is detected.
• Track 0 has been setup.
• Tracking mode selected.
• Proper operator presence mode selected.
• TCM must be installed and turned on.
• AutoTrac Controller Steering Kit is plugged in.
Activating System
CAUTION: While AutoTrac is activated, operator
is responsible for steering at end of path
and collision avoidance.
Do not attempt to turn on (Activate) AutoTrac
system while transporting on a roadway.
After system has been ENABLED, operator must manually
change system to ACTIVATED status when steering
assistance is desired.
Press resume switch. This will initiate assisted steering.
In order to activate system following criteria must be met:
• Vehicle speed is greater than 0.5 km/h (0.3 mph).
• Forward vehicle speed is less than 30 km/h (18.6 mph)
• Reverse vehicle speed is less than 10 km/h (6.0 mph).
• Vehicle within 45 degrees of desired track.
• Operator is seated.
• TCM is on.
• In reverse AutoTrac will remain activated for 45
seconds. After 45 seconds the machine must be put in
a forward gear before reverse will activate again.
30-1 090811
PN=27