JVC DT-V1910CG - Manual (Page 54)

20
HOW TO USE “SETUP MENU”
(cont'd)
Ⅵ CONTRAST
• –20 ~ 00 ~ +20
Ⅵ BRIGHT
• –20 ~ 00 ~ +20
Ⅵ CHROMA
• –20 ~ 00 ~ +20
Ⅵ PHASE
• –20 ~ 00 ~ +20
Ⅵ NTSC SETUP
Sets the set-up level of the input NTSC signal.
00 : Compliant with 0% set-up signal.
7.5 : Compliant with 7.5% set-up signal.
NOTE :
NTSC SETUP is displayed only when the video input card is
installed and an NTSC signal is input.
Ⅵ COMPO. LEVEL
Sets the set-up level of the input component signal.
SMPTE : Compliant with M2VTR signals.
B75
: Compliant with Betacam 7.5% set-up signal.
B00 : Compliant with Betacam 0% set-up signal.
NOTE :
COMPO. LEVEL is displayed only when a 480/60i, 480/60p, 576/
50i or 576/50p signal is input.
COLOR TEMP. :LOW
BLUE DRIVE : 000
RED DRIVE : 000
GREEN CUTOFF : 000
BLUE CUTOFF : 000
RED CUTOFF : 000
sub menu
reset
EXIT: MENU ADJUST:- + SELECT:
COLOR TEMP./BAL.
Sets or adjusts the colour temperature or white
balance.
Press the button to
display the setting menu
illustrated on the right.
• Use the five items indicated with
mark to make fine adjustments
between the monitors.
Ⅵ COLOR TEMP.
Selects the colour temperature.
HIGH : Sets the colour temperature to 9300.
LOW : Sets the colour temperature to 6500.
Ⅵ BLUE DRIVE
Adjusts the blue drive level.
• MIN ~ 000 ~ MAX (in 127 grades)
Ⅵ RED DRIVE
Adjusts the red drive level.
• MIN ~ 000 ~ MAX (in 127 grades)
Ⅵ GREEN CUTOFF
Sets the green cut-off point.
• MIN ~ 000 ~ MAX (in 205 grades)
Ⅵ BLUE CUTOFF
Sets the blue cut-off point.
• MIN ~ 000 ~ MAX (in 205 grades)
Ⅵ RED CUTOFF
Sets the red cut-off point.
• MIN ~ 000 ~ MAX (in 205 grades)
CONTRAST : 00
BRIGHT : 00
CHROMA : 00
PHASE : 00
NTSC SETUP : 00
COMPO.LEVEL :SMPTE
sub menu
reset
EXIT: MENU ADJUST:- + SELECT:
PICTURE SUB ADJ.
Controls the approximate adjustment of the video
control level when the video adjustment knob is
adjusted to the centre.
• Can also be used to switch the NTSC set-up level, and
change the component signal’s input level settings.
Press the button to
display the setting menu
illustrated on the right.
NOTE :
When the RGB signal is input, only
CONTRAST and BRIGHT are
displayed. When the PAL signal is
input, only CONTRAST, BRIGHT
and CHROMA are displayed.
LCT1423-001A_p18-32 4/29/03, 5:08 PM 20