JVC DT-V1910CG - Manual (Page 4)

4
CONTROLS AND FEATURES
FRONT VIEW
Tally lamp
Lights when the tally control signal is ON.
• Set the MAKE/TRIGGER terminal’s tally control in the
REMOTE (external control) terminal setup menu.
The lamp color can be set to red or green.
• To set the color, use TALLY SELECT in the “FUNCTION
SETTING” setup menu or MAKE/TRIGGER in the
REMOTE (external control) terminal setup menu.
For details, refer to Page 19 and 23.
PHASE adjustment knob
Adjusts picture hue.
• Turn the knob to the left to make the picture redder, and
turn it to the right to make the picture greener.
CHROMA adjustment knob
Adjusts picture color density.
• Turn the knob to the left to make the picture color
lighter, and turn it to the right to make the picture color
deeper.
BRIGHT adjustment knob
Adjusts picture brightness.
• Turn the knob to the left to make the picture darker, and
turn it to the right to make the picture brighter.
CONTRAST adjustment knob
Adjusts picture contrast.
• Turn the knob to the left to make the picture contrast
lower, and turn it to the right to make the picture
contrast higher.
VOLUME buttons
Adjusts the speaker volume.
• Pressing this button displays the VOLUME level bar on
the screen. Pressing the button again allows you to
adjust speaker volume.
1
10
2
3
4
5
6
9
11
VOLUME
SLOT 1
A B
DEGAUSS
MENU SCREENS CHECK
ASPECT AREA MARKER
UNDER
SCAN
PULSE
CROSS
COLOR
OFF SLOT 2
C D
SLOT 3 POWER
E F
INPUT SELECT
VOLUME
SLOT 1 A B DEGAUSS
MENU
MUTING
SCREENS CHECK ASPECT AREA MARKER
UNDER SCAN PULSE CROSS COLOR OFF SLOT 2 C D SLOT 3 POWER E F INPUT SELECT
2 3 4 5 8 11 12 13 14
10 9 6 6 15 16 17
18 19 20
1
MUTING
7
8
7
!
!
MUTING button
Pressing this button mutes the output sound.
• To cancel “MUTING ON” (no sound), press MUTING
button again, or press the VOLUME “–” or “+” buttons.
NOTE:
When a menu or setting item (such as MAIN MENU, SETUP
MENU, sub-menu, or VOLUME bar) is displayed on the screen,
this button functions as a control button for the menu screen. In
this case, it will not mute the sound when pressed.
EMBEDDED AUDIO channel switch button
Press this button while the VOLUME bar is
displayed on the screen to change the input
sound channel.
• When the button is pressed, the next highest
channel is selected.
• When the button is pressed, the next lowest channel
is selected.
NOTES:
Switchable channels correspond with the group selected in the
“E.AUDIO GROUP” of the “FUNCTION SETTING” setup menu.
* Valid when an input card compliant with EMBEDDED AUDIO is
installed.
Menu select buttons
Selects menu screen items or set-up menu
screen.
MENU button
Displays, adjusts or closes a menu screen.
DEGAUSS button/lamp
Press the DEGAUSS button. The button lights
and degaussing is performed automatically.
• When the degaussing is completed, the light goes off.
(Front view of DT-V1910CG
shown)
LCT1424-001A_EN_p2-17 11/4/03, 5:07 PM 4