JVC LVT1627-001A - Manual (Page 95)

95
Menu items Selectable settings (Initial setting)
EQ
Flat, Hard Rock, R&B, Pop, Jazz, Dance Music,
Country, Reggae, Classic, User 1, User 2,
User 3 ☞ [98]
Sound
Fader/Balance Adjust fader—speaker output balance between the front
and rear speakers. (00)
F06: front only
R06: rear only
• When using a two-speaker system, set the fader to the
center (00).
Adjust balance—speaker output balance between the left
and right speakers. (00)
L06: left only
R06: right only
Volume Adjust Adjust and store auto-adjustment volume level for each
source, comparing to the FM volume level. The volume
level will automatically increase or decrease when you
change the source.
–12 to +12 (00)
Subwoofer Adjust the settings below in the submenu:
• Phase: Subwoofer phase. Select either Normal or
Reverse, which reproduces a better sound.
• Level: Subwoofer output level. 00 to 08 (04)
High Pass Filter Through: Select when the subwoofer is not connected.
On: Select when the subwoofer is connected.
Crossover Adjust the crossover frequency between the front/rear
speakers and the subwoofer.
55 Hz, 85 Hz, 125 Hz
Amplifier Gain You can change the maximum volume level of this
receiver.
Amplifier Off: Deactivates the built-in amplifier.
Low Power: Volume 00 to 30 (Select this if the maximum
power of the speakers is less than 50 W)
High Power: Volume 00 to 50
Fader/Balance
Exit
F02
L02
AV Menu items
KDNX5000_J.indb 95 KDNX5000_J.indb 95 23/1/07 7:01:02 pm 23/1/07 7:01:02 pm