Integra DTR-5.9 - Manual (Page 82)

82
Advanced Setup
This section explains how to check the speaker settings
and how to set them manually, which is useful if you
change a speaker after performing the automatic speaker
setup.
Some of the speaker settings are set automatically by the
Automatic Speaker Setup function (see page 39).
Speaker Configuration
With the Speaker Configuration settings, you can specify
which speakers are connected and a crossover frequency,
distance, and level for each speaker.
The following crossover frequencies can be specified:
Full Band, 40Hz, 45Hz, 50Hz, 55Hz, 60Hz, 70Hz, 80Hz,
90Hz, 100Hz, 110Hz, 120Hz, 130Hz, 150Hz, or 200Hz.
Specify Full Band for speakers that can output low-fre-
quency bass sounds adequately, for example, speakers
with a good sized woofer. For smaller speakers, specify
a crossover frequency. Sounds below the crossover fre-
quency will then be output by the subwoofer instead of
the speaker. Refer to your speakers’ manuals to deter-
mine the optimum crossover frequencies.
Speaker Setup
1 Press the [Receiver] button fol-
lowed by the [Setup] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2 Use the Up and Down [ ]/[ ]
buttons to select “2. Speaker
Setup,” and then press the
[Enter] button.
This setting is set automatically by the Automatic
Speaker Setup function (see page 39).
3 Use the Up and Down [ ]/[ ]
buttons to select “2. Speaker
Configuration,” and then press
the [Enter] button.
4 While the “Subwoofer” setting is
selected, use the Left and Right
[
]/[ ] buttons to select Yes or
No .
Yes: Select if a subwoofer is con-
nected.
No: Select if no subwoofer is con-
nected.
5 Use the Down [ ] button to
select “Front,” and then use the
Left and Right [
]/[ ] buttons to
select a crossover frequency.
Note:
• Fixed at Full Band if Subwoofer
(step 4) is set to No.
6 Use the Down [ ] button to
select “Center,” and then use the
Left and Right [
]/[ ] buttons to
select a crossover frequency.
If no center speaker is connected, select
None.
Note:
• Cannot select Full Band if Front
(step 5) is set to anything other than
Full Band.