First time setup, Automatic speaker setup, Setup mic (39) – Integra DTR-5.9 User Manual

Page 39

First Time Setup

This section explains the settings that you need to make before using the AV receiver for the very first time.

With the supplied calibrated microphone, Audyssey 2EQ
automatically determines the number of speakers con-
nected, their size for purposes of bass management,
optimum crossover frequencies to the subwoofer (if
present), and distances from the primary listening posi-
tion. Audyssey 2EQ then removes the distortion caused
by room acoustics by capturing room acoustical prob-
lems over the listening area in both the frequency and
time domain. The result is clear, well-balanced sound for
everyone. Enabling Audyssey 2EQ allows you to also
use Audyssey Dynamic EQ, which maintains the proper
octave-to-octave balance at any volume level. (See
page 80)

Measurement Positions

To create a listening environment in which several
people can enjoy your home theater simultaneously,
Audyssey 2EQ takes measurements at three positions
within the listening area.

First measurement point

This is the center point of the listening area, or the
listening position.

Second measurement point

The right side of the listening area.

Third measurement point

The left side of the listening area.

The distances between points

and

and points

and

must be at least 1 meter.

From the examples below, choose the listening area that
best matches yours and place the microphone accord-
ingly when prompted.

Using Audyssey 2EQ

Automatic Speaker Setup

Listening area

Listening position

The onscreen setup menus appear only on a TV that is
connected to the HDMI OUT. If your TV is connected
to the composite video or S-Video MONITOR OUT,
or the COMPONENT VIDEO OUT, use the DTR-
5.9’s display when changing settings.

Turn on the AV receiver and the
connected TV.

On the TV, select the input to which the
AV receiver is connected.

Notes:
• If any of your speakers is 4 ohms, change the

Speaker Impedance setting before running the
automatic speaker setup (see page 43).

• If the AV receiver is muted, it will be unmuted

automatically when the automatic speaker setup
starts.

• Automatic speaker setup cannot be performed

while a pair of headphones is connected.

• It takes about 10 minutes to complete the auto-

matic speaker setup for three positions. Total mea-
surement time varies depending on the speakers.

• Do not connect or disconnect any speakers during

the automatic speaker setup.

3-7

2, 8