Integra DTR-5.9 - Manual (Page 57)

57
Listening to the Radio —Continued
Setting the Satellite Radio Mode
Before you can listen to SIRIUS Satellite Radio, you
must set the Satellite Radio mode to SIRIUS.
Selecting SIRIUS Satellite Radio
1 Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
The main menu appears onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select “7. Hardware
Setup,” and then press [Enter].
The Hardware Setup menu appears.
3 Use the Up and Down [ ]/[ ]
buttons to select “3. Tuner,” and
then press [Enter].
The Tuner screen appears.
Receiver
Tuner
Setup
Enter
Menu
1. Input Assign
2. Speaker Setup
3. Audio Adjust
4. Source Setup
5. Listening Mode Preset
6. Miscellaneous
7. Hardware Setup
8. Lock Setup
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
7-3.Tuner
SAT Radio Mode None
4 Use the Up and Down [ ]/[ ]
buttons to select “SAT Radio
Mode.”
Pressing the Left and Right [ ]/[ ]
buttons cycles through the following
options: None
↔
SIRIUS
None : Select if you’re not using
satellite radio.
SIRIUS : Select to use SIRIUS Satel-
lite Radio.
5 When you’ve finished, press the
[Setup] button.
Setup closes.
On the AV receiver, press the
[Tuner] Input Selector button
repeatedly to select SIRIUS.
On the remote controller, press
the [Receiver] Remote Mode but-
ton, and then press the [Tuner]
Input Selector button repeatedly
to select SIRIUS.
If “CHECK SR TUNER” appears on
the display, make sure the SiriusCon-
nect receiver is connected properly. If
“ANTENNA ERROR” appears, make
sure the antenna is connected properly.
Remote
controller
AV receiver