Turning on the av receiver, Connecting the power cord, Turning on and standby – Integra DTR-5.9 User Manual
Page 38: Connecting the power cord turning on and standby, Utton (38), Y indicator (38)
38
Turning On the AV Receiver
• Before connecting the power cord, connect all your speakers and AV components.
• Plug the end of the power cord into a suitable wall outlet.
• Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical equipment
on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.
On/Standby
Receiver
On/Standby
Standby indicator
Connecting the Power Cord
Turning On and Standby
The onscreen setup menus appear only on a TV that is connected to the HDMI OUT. If your TV is connected to the
composite video or S-Video MONITOR OUT, or the COMPONENT VIDEO OUT, use the DTR-5.9’s display when
changing settings.
On the AV receiver, press the [On/Standby] button.
On the remote controller, press the [Receiver] Remote Mode button, fol-
lowed by the [On/Standby] button.
The AV receiver comes on, the display lights up, and the Standby indicator goes off.
To turn the AV receiver off, press the [On/Standby] button, or press the remote con-
troller’s [On/Standby] button. The AV receiver will enter Standby mode. To prevent any
loud surprises the next time you turn on the AV receiver, turn down the volume before
you turn it off.
Remote
controller
AV receiver
or
Up and Running in a Few Easy Steps
To get your system up and running with the minimum of fuss, here’s a few pointers to help you configure the AV
receiver before you use it for the very first time. These settings only need to be made once.
■ Do the automatic speaker setup—this is essential!
See “Automatic Speaker Setup” on page 39.
■ Did you connect a component to an HDMI input,
component video input, or digital audio input?
If you did, see “HDMI Input Setup” on page 44, “Component Video
Input Setup” on page 45, or “Digital Input Setup” on page 45 respec-
tively.
■ Did you connect an Onkyo MD recorder, CD recorder, or RI
Dock?
If you did, see “Changing the Input Display” on page 46.
OPTICAL
COAXIAL
Y
P
B
P
R
HDMI
OUT
IN
TAPE
MD recorder, CD recorder,
RI Dock