Defining spanning tree interface settings – Intel AXXSW1GB User Manual
Page 102
Intel® Gigabit Ethernet Switch AXXSW1GB User Guide
89
Defining Spanning Tree Interface Settings
Network administrators can assign STP settings to specific interfaces using the Spanning
Tree Interface Settings Page. The Global LAGs section displays the STP information for
Link Aggregated Groups.
To assign STP settings to an interface:
1. Click Layer 2 > Spanning Tree > Interface Settings. The Spanning Tree Interface
Settings Page opens:
Figure 66. Spanning Tree Interface Settings Page
The Spanning Tree Interface Settings Page contains the following fields:
•
Ports — Displays the port on which STP is enabled
.
•
LAGs — Displays the LAG on which STP is enabled.
If Ports are selected, the following fields are displayed:
•
Port — Displays the port for which the information is displayed.
•
LAG — Displays the LAG for which the information is displayed
•
STP — Indicates if STP is enabled on the port. The possible field values are:
— Enabled — Indicates that STP is enabled on the port.
— Disabled — Indicates that STP is disabled on the port.
•
Port Fast— Indicates if Fast Link is enabled on the port. If Fast Link mode is enabled
for a port, the Port State is automatically placed in the Forwarding state when the port