IBM 19 - Manual (Page 334)

b. Pull up the green handle on the OPC belt cartridge and then pull
the cartridge out about 2" (5 cm) to relieve tension on the drum.
c. Remove the media from the transfer unit end of the printer (fig.
9.7).
d. Close the transfer unit and the back cover.
e. Firmly push the OPC belt cartridge back into the printer until it
snaps into place. The cartridge is in place when you can see the
green arrows on the left and right inside metal frame of the
printer. Then, push down the green handle to lock the OPC
cartridge in place, and close the manual feed tray.
f. Skip to step 5.
4. Remove the jammed media if the media is around the fuser
roller by using the following procedure.
Fig. 9.7 Remove the Jammed Media
Chapter 9
9 - 1 2 T r o u b l e s h o o t i n g
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500