Section 12—electronics, Removing/installing the joystick – Invacare Wheelchair Pronto M61 User Manual
Page 71

SECTION 12—ELECTRONICS
71
Pronto® M51™and M61™with SureStep®
SECTION 12—ELECTRONICS
ƽ WARNING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
Removing/Installing the Joystick
NOTE: For this procedure, refer to FIGURE 12.1 on page 72.
Removing
1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 74.
2. Cut the tie‐wraps that secure the joystick cable to the arm.
3. Loosen the adjustment lock lever to release the joystick mounting tube from the
mounting bracket. Refer to FIGURE 12.1 on page 72.
4. Remove the joystick and joystick mounting tube from the mounting bracket.
Installing
1. Slide joystick mounting tube through the mounting bracket to the desired position.
2. Tighten the adjustment lock lever to secure the joystick mounting tube to the
mounting bracket on the other arm.
3. Tie‐wrap the joystick cable to the arm as shown in FIGURE 12.1 on page 72.
4. Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 74.